Design, Modelling and Analysing of a Vehicle Drivetrain using SimDriveline
Keywords:
Abstract
In the vehicle industry, it is required to model a Vehicle Drivetrain based on a well-recognized system and analyze the system behavior with the aim to redesign or modify the system to meet different operational requirements. So, this paper aimed to Design, Modelling, and Analyzing of a Vehicle Drivetrain using SimDriveline. The followed methodology was divided into four steps, which are; Analysis of Variable and Simple Gear Systems, Analysis of Simple Hydraulic Clutch System, Modelling and Investigation of a Vehicle Drivetrain, as well as Model-based design of a simple power transmission system using SimDriveline. The results of this paper showed that in the simple gear with introducing one of the meshings there was a slight decrease in velocity and the torque was unstable and not smooth. In the variable gear, the velocity has considerably decreased wherein the torque was increased. Also, in the clutch, the pressure has increased after modifying the input signal and the engine power in the earlier times. The change was very small after changing the simple gear with variable gear in the drivetrain vehicle model which cannot be taken into consideration however, when the physical constant block has replaced by throttle there was a big effect on the engine power as well as the vehicle speed.
References
Cheng, R., Dong, J., & Dong, Z, Modelling and simulation of a multiple-regime plug-in hybrid electric vehicle. In ASME 2013 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference, 2013.
Fang, Ch., Cao, Z., Ektesabi, M., Kapoor, A., & Sayem, A, Driveline modelling analysis for active driveability control". In Systems, Process & Control (ICSPC), 2013 IEEE Conference. Kuala Lumpur, Malaysia: IEEE, 2013.
Mousavi, M., Saman, R., Pakniyat, A., & Boulet, B., Dynamic modeling and controller design for a seamless two-speed transmission for electric vehicles. Control Applications (CCA), 2014 IEEE Conference. Juan Les Antibes, France: IEEE, 2014.
Pawlus, W., Hovland, G., & Choux, M., Drivetrain design optimization for electrically actuated systems via mixed integer programming. In Industrial Electronics Society, IECON 2015 – 41st Annual Conference of the IEEE. Yokohama, Japan: IEEE, 2015.
Tomasikova, M., Nieoczym, A., & Brumercik, F., Vehicle drivetrain modelling. In Transcom Proceedings 2015, 11-th European Conference of Young Researches and Scientists, 2015, 265-268.
Wallmark, O., & Nybacka M., Design and implementation of an experimental research and concept demonstration vehicle. In Vehicle Power and Propulsion Conference (VPPC), IEEE, 2014.
Zhou, J., Shen, X., & Liu, D., Modeling and simulation for electric vehicle powertrain controls. In Transportation Electrification Asia-Pacific (ITEC Asia-Pacific), IEEE Conference and Expo. Beijing, 2014.
Zilina, Slovak Republic. Tomasikova, M., Brumercik, F., & Nieoczym, A., Vehicle simulation model creation. LOGI, Scientific Journal on Transport and Logistics, 6(1), 2015, 130–136.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2020 Asian Journal of Applied Science and Engineering
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.